1972-1981 GM UMI Front Bump Steer Adjuster Set 2660

UMI's 1972-1981 GM bump steer kit is designed to reduce or eliminate toe change during suspension travel (also known as bump steer). Reduction of bump steer improves handling and straight line stability and enhances overall precision of the steering system. These direct bolt-in kits allow the builder to relocate the outer tie rod end lower than stock (or higher if necessary). The stud taper is designed for exact factory fit for each application and is constructed of 4140 CrMo for strength and durability, no spindle drilling required. The adjuster is 6061-T6 Aluminum hex for lightweight strength and features a hard anodized protective finish. Kits include shims of 0.125 inch, 0.1875 inch and 0.250 inch. These race-tested bump steer kits are 100% designed and manufactured with pride in Philipsburg, PA - USA.Features:4140 CrMo stud constructionRace quality rod end, jam nuts and locking hardwareLaser cut spacers of 0.125 inch, 0.1875 inch and 0.250 inch6061-T6 Aluminum toe adjuster, hard anodized, 5/8th RH and 11/16th LH threads, 9.125 inch sleeve lengthDouble check 9.125 inch sleeve length before ordering, as there were various steering systems throughout this platformWorks with factory inner tie rods and factory spindleSimply bolt-on. No spindle drilling requiredInstructions with technical links includedManufactured with pride in Philipsburg, PA - USABattle tested by UMI

Manufacturer Part Number : 2660

Part Notes:

IF USED ON 1970-1971 CAR, CENTER LINK AND INNER TIE RODS MUST BE USED FROM 1972-1981 MODEL. SIMPLY BOLT-ON. NO DRILLING REQUIRED.